Automatic Mounting Press, fully automatic microprocessor controlled operation, touch pad front panel controls and digital display of heating time, molding temperature, cooling temperature, ram up/down, auto/manual cooling, cycle start/stop and a direct reading pressure gauge. Molding pressure up to 310 Bar, molding temperature up to 240°C, thermostatically controlled heating power of 1400 W, automatic cooling cycle and an audible signal for end of cycle. Last molding parameter settings retained in memory. Supplied with all necessary hoses, fittings, power cord and instruction manual, selectable mould sizes from 25 to 50mm.

Order No: 25 02

Semi-automatic Mounting Press, 5 ton capacity. Touch pad front panel controls and digital display of heating time, molding temperature, cooling temperature, ram up/down, auto/manual cooling, cycle start/stop and a direct reading pressure gauge. Self contained bench design, integral heating and cooling unit, thermostatically controlled heating power of 1400 W, automatic cooling cycle, with audible warning signal and ready for operation , selectable mould sizes from 25 to 50mm.

Order No: 20 01

Fully automatic microprocessor controlled operation. Touch pad front panel controls and digital display for heating time, moulding temperature, cooling temperature, ram up/down, auto/manual cooling, cycle start/stop and a direct reading pressure gauge. Thermostatically controlled heating power, automatic cooling cycle and an audible signal for end of cycle. Last molding parameter settings retained in memory. Will accept moulds of 25 to 40 mm in diameter.

Order No: 25 03

The same as HYDROPRESS 50, however for selectable mould sizes of 60 and 70 mm.

Order No: 25 04

Vacuum Impregnation Unit for cold mounting. Especially designed for embedding and impregnation of porous materials under vacuum. In addition, glueing of specimens to glass slides for thin section analysis is possible. Vacumet is very simple to operate and ensures efficient impregnation.